1. Basic composition and core components
The inverter is mainly composed of the following core components:
Inverter bridge: It is composed of power electronic switching devices (such as MOSFET, IGBT), which realizes the conversion from DC to AC by alternating on and off.
Control logic unit: Usually a PWM controller (such as TL5001, TL494 chip) is used to generate high-frequency switching signals to adjust the output voltage and frequency.
Filter circuit: It is used to smooth the output waveform, filter out high-frequency harmonics, and make the AC close to a sine wave.
2. Detailed explanation of working principle
The working process of the inverter can be divided into the following steps:
DC input and signal control
The input interface receives DC power supply (such as 12V/24V battery) and control signals (such as ENB enable signal, DIM dimming signal), and adjusts the output current through the PWM controller.
High-frequency switching conversion
The switch tube in the inverter bridge is quickly turned on and off according to the PWM signal, cutting the DC into a pulse sequence. For example, two sets of switch tubes in a full-bridge inverter are turned on alternately to generate a square wave with positive and negative half cycles.
Waveform modulation and boosting
The square wave is converted into high-voltage AC (such as 1600V starting voltage, which is then reduced to 800V stable output) through an LC oscillation circuit or transformer boosting.
Filtering and output
The filter circuit (such as capacitors and inductors) eliminates high-frequency noise and outputs pure 50Hz/60Hz sine waves or corrected wave AC.
3. Key technology: Pulse width modulation (PWM)
Principle: Control the effective value of the output voltage by adjusting the pulse width (duty cycle), while fixing the frequency to ensure output stability.
Advantages: Improve energy efficiency, reduce harmonic interference, and support wide range voltage/frequency adjustment.
4. Typical application scenarios
Car inverter: Convert the 12V DC power of the car into 220V AC power for use by electronic equipment.
Household appliances: Such as air conditioners, computers, etc., rely on inverters to provide stable AC power.
5. Classification and working mode
Half-bridge inverter: uses two switch tubes, and the output amplitude is half of the input voltage.
Full-bridge inverter: four switch tube structure, the output amplitude is equal to the input voltage, and the efficiency is higher.
